Yesterday we went to review the DXF files and how they were going to be imported to AutoCad and test cut some cardboard. When we showed up, the station looked like a snake with funky curve lines and weird angles, something was just not quite right.
We ended up converting the dimensions from mm to inches to properly size for cutting. Additionally we needed to remove the center line due to the inability to properly import and modify the DXF files in AC, then nest to fit the 10 MDF sheets required for all the stations. In the end, with the conversion complete, we ran 2 samples, a main hull and float station.
After comparing the station samples against the full size patterns, they matched very well. We were good to go for the next evening so after work the next day we picked up the materials and set off to the Laser Cutting. We arrived with MDF in tote, ready to get moving on the Laser. It was an exciting time, knowing that the station cutting was going to be completed tonight, without having to transfer the patterns & manually cut, a great time saver!
After modifying position we were ready to begin, now came the time to start cutting.
After our initial stations were lasered, we cross compared again against the full size patterns, they matched very well:
we were pleased and continued to complete the remaining 9 sheets. Here are a couple station shots (-:
With stations complete, we transfered them to the shop. The 1st Milestone has been reached!
Next is to begin working on the strongback however with Thanksgiving upon us, it looks like this will begin next week after I recover from all the Turkey and Pumpkin Pie